ThruLink 3 Standard Capacity with LTE Plus Update
ThruLink 3 Standard Capacity with LTE Plus Update
Description
6.2.1.10 - 20240125
- Implement secure discovery protocol that allows for IP identification and resetting of the unit. Useful to identify a forgotten IP address.
- Include advanced routing configuration in wancheck. During a service restart any existing advanced routing routines would be removed.
- Disconnect RX/TX RF circuits before rebooting when in LTE mode. Previously powering down the module could cause a panic on the communication interface.
- Fix a bug where the subnet was not been set correctly on the WAN interface.
- Show chipset sub version when in LTE mode.
- Improve removal of stale nodes/edges from active connection list.
- Prefered MTU size occurs more often which improves packet size discovery.
- WAN check now deals with interfaces that don't become active after a period of time. Before the service would wait until activity occured before progressing. It now assumes something has gone wrong and forces a reboot.
- During a reboot, first disconnect from any active session. This should reset any PDU to CPE network session.
- Improve storing and loading of platform identity to be used for validation when upgrading.
- Display Connection Type within signal strength indicator.
6.2.1.10 - 20240125
- Implement secure discovery protocol that allows for IP identification and resetting of the unit. Useful to identify a forgotten IP address.
- Include advanced routing configuration in wancheck. During a service restart any existing advanced routing routines would be removed.
- Disconnect RX/TX RF circuits before rebooting when in LTE mode. Previously powering down the module could cause a panic on the communication interface.
- Fix a bug where the subnet was not been set correctly on the WAN interface.
- Show chipset sub version when in LTE mode.
- Improve removal of stale nodes/edges from active connection list.
- Prefered MTU size occurs more often which improves packet size discovery.
- WAN check now deals with interfaces that don't become active after a period of time. Before the service would wait until activity occured before progressing. It now assumes something has gone wrong and forces a reboot.
- During a reboot, first disconnect from any active session. This should reset any PDU to CPE network session.
- Improve storing and loading of platform identity to be used for validation when upgrading.
- Display Connection Type within signal strength indicator.
